Jasa Alignment Turbin Compressor

Jasa Alignment Turbin Compressor direport langsung dari alat alignment sehingga data yang akan dilaporkan nantinya akan sama dengan yang dilihat pada layar alat yang  digunakan tersebut.

Mohon disertakan gambar supaya mempermudah dalam mempersiapkan alat dan tenaga sehingga mempermudah dalam proses pengerjaan Jasa Alignment Turbin Compressor.

(tool alignment portable merk Pruftechnik AG Germany, Oneprod by ACOEM, Hammar, Fixturlaer)

Hubungi Kami

HP/WA : 0811 904 824

Request by email: agus@maintenance.my.id

1. Diameter Blower Impeller dan beratnya (kg) ?
2. Material nya terbuat dari bahan apa ?
3. Diameter AS/Shaft dan panjang nya ?
4. KW atau HP motor penggeraknya ?
5. RPM ?
6. Lokasi pekerjaan (untuk balancing onsite) ?
7. Nama Perusahaan dan Alamat lengkap ?
8. Gambar dan foto mesin ?

Yang harus dipersiapkan untuk melakukan laser shaft alignment yaitu :

  1. Peralatan atau mesin yang akan di alignment harus benar-benar tidak dapat di operasikan.
  2. Pengecekan pondasi dan baut-baut pengikat harus dalam kondisi baik.
  3. Persediaan Shim yang lengkap untuk mengganjal alat yang di alignment.
  4. Maksima 4 tumpukan Shim
  5. Tidak ada tarikan pipa jika pompa
  6. Data mesin yang cukup, seperti RPM, Thermal Grouth, getaran dan kondisi mesin yaitu baru atau lama.
  7. Alat laser alignment yang terbaik dan operator yang berpengalaman serta helper untuk membuka dan mengencangkan baut.
Jasa Laser Shaft Alignment

Alignment Chart

Alignment tolerance chart from the American National Standard Institute (ANSI) Shaft Alignment Methodology, Part 1: General Principles, Methods, Practices, and Tolerances. The statement above the table shows that the RPM is the deciding factor in shaft-to-shaft tolerances. The faster the machine runs, the tighter the tolerance.

If you look at the tolerances, you will see it written in metric and imperial. In the brackets, the tolerance is in mils. A mil is the same as a thou, it’s just written differently. One mil equals one thou — i.e., 1.0 mil = 0.001 inch (thou). Mils are used throughout North America, although mainly in the U.S., as this is an ANSI standard.

If we look at the table under 1,800 RPM, which is the most common RPM in the industry, it shows the allowable tolerances divided into three ranges:

Minimal – 6.0 mils of offset and 1.2 mils per inch of angle.
Standard – 3.0 mils of offset and 0.6 mils per inch of angle.
Precision – 1.6 mils of offset and 0.3 mils per inch of angle.

When comparing the minimal ANSI tolerances to the tolerances of the jaw coupling in thou:
– The coupling tolerance is 0.062” of offset, 0.01745” per inch of angle.
– The ANSI standard is 0.006” of offset, 0.0012” per inch of angle.

Scroll to top